Catalog
Else categories
The pump for high pressure 9m Qmax Hmax 120W 30l / min ؾ inch 160mm + nuts ؽ inch AQUATICA (774711)
Overview
A pump for increasing the pressure 120W Hmax 9m Qmax 30l / min ؾ 160mm + nuts ؽ AQUATICA (774,711) These pumps are designed for pumping and pressurizing the existing water supply system. They can be used to create a pressure front heaters, gas water heater, washing machines and dishwashers, as well as to increase the water pressure in the shower or other points of demand. Pumping Unit: - Body: cast iron; - The motor shaft: ceramic; - Impeller: technopolymer. Motor: - Motor type: asynchronous, low noise; - the stator windings of copper; - motor stator sleeve: Stainless steel AISI 304; - Bearing: Ceramic groove; - Voltage: 220-240V; - Frequency: 50 Hz; - Insulation class: H; - Degree of protection: IP42; - Cable length: 1 m; - Flow sensor for auto on / off with a flow rate at the point of demand. Tube: - DN1: ¾ "; - Thread adapters: ½". Application conditions: - Maximum temperature of the pumped Well
Characteristics
| Producer | AQUATICA |
| Pump capacity, cu.m/hour | 1.8 |
| Feed height, m | 9 |
| Power capacity, kW | 0,12 |
| Power supply | 1х220 V, 50 Hz |
| Nom.pressure, Mpa | 6 |
| Max.flow rate, m3/h | 1.8 |
| Length, mm | 160 |
| Max.medium temperature, Celsius degree | 60 |
| Max.head, meter of water column | 9 |
| Width, mm | 104 |
| The diameter of loaded solid particles, mm | 0.2 |
| Nom.head, m | 5 |
| Max. head, m | 9 |
| Height, mm | 126 |
| Impeller material | tecnopolymer |
| Country of Origin | China |
| Availability of spare parts | Yes |
Products from the same category
Pre-order only
