Catalog
Else categories
The pump for high pressure 123Vt Qmax Hmax 9m 25l / min ؾ inch 160mm + nuts ؽ inch LEO 3.0 (774741)
Overview
A pump for increasing the pressure 123Vt Hmax 9m Qmax 25l / min ؾ 160mm + nuts ؽ LEO 3.0 (774741) These pumps are designed for pumping and pressurizing the existing water supply system. They can be used to create a pressure front heaters, gas water heater, washing machines and dishwashers, as well as to increase the water pressure in the shower or other points of demand. Pumping Unit: - Body: cast iron; - Engine shaft: cermet based on aluminum oxide; - Impeller: technopolymer with heat resistance up to 150 ° C. Motor: - Motor type: asynchronous, low noise; - the stator windings of copper; - motor stator sleeve: Stainless steel AISI 304; - Bearings: cermet based on aluminum oxide; - Voltage: 220-240V; - Frequency: 50 Hz; - Insulation class: H; - Degree of protection: IP42; - Cable length: 1 m; - Flow sensor for auto on / off with a flow rate at the point of demand. Tube: - DN1: ¾ "; - re Thread
Characteristics
| Producer | LEO |
| Pump capacity, m3/h | 1.5 |
| Feed height, m | 9 |
| Power capacity, kW | 0,123 |
| Power supply | 1х220 V, 50 Hz |
| Max.flow rate, m3/h | 1.5 |
| Length, mm | 160 |
| Max.medium temperature, Celsius degree | 60 |
| Width, mm | 104 |
| The diameter of loaded solid particles, mm | 0.2 |
| Nom.head, m | 5 |
| Max. head, m | 9 |
| Height, mm | 126 |
| Pressure, bar | 6 |
| Country of Origin | China |
| Availability of spare parts | Yes |
