Catalog
Else categories
The pump for high pressure 270Vt Qmax Hmax 12m 47l / min ؾ inch 195mm + nuts ؽ inch AQUATICA (774714)
Overview
A pump for increasing the pressure 270W Hmax 12m Qmax 47l / min ؾ "+ 195mm nut ؽ" AQUATICA (774,714) These pumps are designed for pumping and pressurizing the existing water supply system. They can be used to create a pressure front heaters, gas water heater, washing machines and dishwashers, as well as to increase the water pressure in the shower or other points of demand. Pumping Unit: - Body: cast iron; - The motor shaft: ceramic; - Impeller: technopolymer. Motor: - Motor type: asynchronous, low noise; - the stator windings of copper; - motor stator sleeve: Stainless steel AISI 304; - Bearing: Ceramic groove; - Voltage: 220-240V; - Frequency: 50 Hz; - Insulation class: H; - Degree of protection: IP42; - Cable length: 1 m; - Flow sensor for auto on / off with a flow rate at the point of demand. Tube: - DN1: ¾ "; - Thread adapters: ½". Application conditions: - Maximum temperature pumpability
Characteristics
| Producer | AQUATICA |
| Pump capacity, cu.m/hour | 2.8 |
| Feed height, m | 12 |
| Power capacity, kW | 0,27 |
| Power supply | 1х220 V, 50 Hz |
| Nom.pressure, Mpa | 6 |
| Max.flow rate, m3/h | 2.8 |
| Length, mm | 150 |
| Max.medium temperature, Celsius degree | 60 |
| Max.head, meter of water column | 12 |
| Width, mm | 132 |
| Max. head, m | 12 |
| Height, mm | 195 |
| Pressure, bar | 6 |
| Impeller material | tecnopolymer |
| Country of Origin | China |
| Availability of spare parts | Yes |
Products from the same category
Pre-order only
